
How to Clean Greasy Soot Off Your Car
Has your car, or a friend’s, been through a garage fire? The first thing to know is that a normal wash won’t get the soot off. It’s thick, greasy, clings to everything, and pushes water away. Here’s how to get it off the paint safely.

What You’ll Need
- Lots of cheap microfiber towels (you’ll throw them away afterward)
- A bucket of water with car wash soap
- An all-purpose cleaner, such as Meguiar’s All Purpose Cleaner diluted 8:1 (it worked better than a degreaser like Super Clean)
- Detail brushes
- A water hose
- A drying towel
- A clay bar
- Detail spray (optional)
Before You Start
You’re removing more than what you can see: the smoke smell clings to the soot, so being thorough matters. Work indoors or in the shade, and don’t let the all-purpose cleaner dry on the paint.
Step by Step
- Soak the microfiber towels in the soapy water.
- Rinse the whole vehicle to remove loose particles.
- Spray one panel with the all-purpose cleaner and let it sit for about 15 seconds.
- Squeeze out a towel until it’s barely dripping and fold it into fourths.
- Gently wipe the panel in straight lines.
- Turn the towel over when it’s dirty or starts leaving streaks.
- Once you’ve gone over the panel, rinse it thoroughly.
- If soot is still there, spray the panel again and repeat the wiping and rinsing.
- Clean all the glass the same way.
- Pay close attention to body lines, door jambs, moldings, bumpers, grilles, and every crack and crevice. That’s where the detail brushes come in.
Once the paint is done, use the same method on each wheel, tire, and wheel well, one at a time.
Clay the Paint
With everything clean, use the clay bar to pull out the contaminants that are bonded to the paint and that the cleaner didn’t get. Clay needs a lubricant between it and the paint; plain water isn’t enough. Detail spray works best, or a little car wash soap in fresh water (don’t overdo the soap).
Spray the panel with detail spray, or wet it from a soapy towel. Glide the clay bar back and forth until the area feels smooth. Don’t press hard: pressure can mar and scratch the paint, and claying doesn’t need it. Fold the clay to a clean side when it looks dirty, or every couple of panels. Then dry the panel or rinse it, depending on the lubricant you used, and move on until the whole vehicle is done.
Finish With a Wash and Protection
To finish, give the vehicle one more normal wash and dry it. Dress the tires if you like, then apply your favorite sealant to protect the paint. Step back and enjoy a vehicle that looks like itself again.
Smoke smell inside the car is a separate job: soot settles into the carpets, seats, and vents, and needs a thorough interior detail to get out.
Fire, Soot, or Smoke Damage?
We clean vehicles inside and out with our interior and exterior detailing. Send the estimate form and tell us what happened.
15017 E 72nd Pl N, Owasso, OK 74055
Mon–Fri 9am–6pm · Sat 12pm–6pm (calls only) · Sun Closed